Free Siding Contractor Matching Vinyl, Fibre Cement, Wood & Metal Siding Across Ottawa
Find a Siding Contractor

Siding Costs in Ottawa, Layer by Layer

A siding quote is more than the boards you see. Each page below takes one job and lays out the wall behind it: the old siding coming off, the new siding, the flashing and trim, the sheathing membrane, any insulation added and any sheathing replaced. For each layer it gives the Ontario Building Code rule, a published price where enough exist, and the line to ask for in your quote.

Published Ontario contractor price pages, 2025 to 2026 · reviewed 2026-09-30 · How we set these ranges

The layers behind every siding job

These layers are part of most jobs whatever the siding is. The rules and the quote line for each are set out once here; each cost page links back to them and adds only what is specific to its material.

  1. Old siding off, and disposal

    • Health Canada lists exterior siding among the pre-1990 building materials that may contain asbestos and advises having old material tested before work starts. (Health Canada, renovation safety, §4)
    • If a professional finds asbestos, Health Canada says to hire a qualified asbestos removal specialist to remove it before starting work. (Health Canada, §4)
    • Ontario's asbestos regulation covers the employers and workers on repair and alteration work. (O. Reg. 278/05 s.2(1)(b), §4)
    • The City's Trail Waste Facility charges $172.70 per tonne for residential garbage, including construction material from the home owner, with a $43.20 minimum for loads under 250 kg. It does not accept asbestos or commercial garbage. (City of Ottawa, Trail Waste Facility rates 2026, §4)

    Published price: About $1 to $3 per square foot of wall for removal, on published Ontario contractor price pages, 2025 to 2026.

    Quote line to ask for: Removal as its own line: the price per square foot, how many old layers it assumes, and whether hauling and disposal are included.

  2. Flashing, trim and corners

    • Flashing goes at every horizontal junction between cladding elements and every horizontal offset, unless the upper cladding overlaps the lower by at least 25 mm. (9.27.3.8.(1), (2)(a))
    • Over a window or door, flashing is needed where the distance from the bottom of the eave to the top of the trim is more than one-quarter of the eave overhang. (9.27.3.8.(3))
    • Flashing extends at least 50 mm up behind the sheathing membrane, slopes at least 6% to the outside and ends in a drip at least 5 mm out from the wall. (9.27.3.8.(4))
    • Sealant goes between the siding and the door and window frames or trim, unless that spot is completely protected from rain. (9.27.4.1.(2))

    Published price: Too few published prices to quote trim and flashing on their own. Ask whether they sit inside the per-square-foot figure.

    Quote line to ask for: Flashing at each horizontal junction and over each opening, plus trim and corners, as listed lines rather than "as needed".

  3. Sheathing membrane (house wrap)

    • At least one layer of sheathing membrane goes beneath siding, conforming to CAN/CGSB-51.32-M, with joints lapped at least 100 mm and upper sheets over lower sheets. (9.27.3.2., 9.27.3.3.)
    • The membrane is the second plane of protection: it intercepts any rain or snow that gets past the siding and drains it to the outside. (9.27.2.3.(1), 9.27.3.1.(1))
    • The Code's explanatory notes say the sheathing membrane is not a waterproof material. (Appendix A-9.27.3.1.)

    Published price: Too few published prices to quote house wrap on its own. Ask whether the per-square-foot price includes new membrane.

    Quote line to ask for: New sheathing membrane over the whole wall, named, with the lap direction written into the scope.

  4. Exterior insulationonly in some jobs

    • Low-permeance board insulation on the outside of the wall has placement rules: on the warm side, with enough insulation outboard of it for the climate, or outboard of a drained and vented air space at least 10 mm deep behind the cladding. (9.25.5.1., 9.25.5.2.)
    • Where non-wood-based rigid insulating sheathing, or insulating sheathing with a built-in membrane, is installed, a separate sheathing membrane is not required. (9.27.3.4.(1))

    Published price: Too few published Ontario prices to quote a range. Ask for the insulation priced as its own line.

    Quote line to ask for: The insulation product, its thickness and R-value, and how the siding is fastened back through it to the framing.

  5. Sheathing, only if damagedonly in some jobs

    • Cladding is fastened to the framing, to furring or to blocking. (9.27.5.1.(1))
    • Vertical lumber and vertically applied vinyl may be fastened to the sheathing alone only where the sheathing is at least 14.3 mm lumber, 12.5 mm plywood or 12.5 mm OSB. (9.27.5.1.(2))
    • Vertically applied metal siding may be fastened to the sheathing alone only where it is at least 14.3 mm lumber, 7.5 mm plywood or 7.5 mm OSB. (9.27.5.1.(3))
    • Where a wall has no sheathing, at least two layers of sheathing membrane go beneath the cladding. (9.27.3.5.(1))

    Published price: Too few published Ontario prices to quote a range. Damage is only visible once the old siding is off.

    Quote line to ask for: A unit price for replacing damaged sheathing, agreed in writing before the old siding comes off.

Every dollar figure is per square foot of wall unless it says otherwise, and every one is a published estimate, not a quote. Your wall area, the layers behind the old siding and the material you pick decide your price.

Find a Siding Contractor