Insulated vinyl R-value on an Ontario house, how much?
Insulated vinyl R-value on an Ontario house, how much?
Insulated vinyl siding adds RSI 0.35 to 0.70, which Natural Resources Canada describes as "not high." That is the R-2 to R-4 range in imperial units, and it is the figure NRCan publishes for insulated siding products as a category.
What that number means for your house depends on a few things worth understanding before you buy.
NRCan notes that insulated siding should incorporate a drainage feature, and that strapping behind siding allows a drainage plane and reduces heat build-up. The Code's explanatory notes (Appendix A-9.27.3.1. of the 2024 Ontario Building Code) say a drained space at least 10 mm deep is recommended for walls other than masonry; that is a recommendation in the notes, not a Code requirement.
Where the insulation question gets more complicated is if you are also adding a separate layer of rigid foam board under the siding, on top of the insulated vinyl, or in combination with it. Sheet or panel materials with low air leakage and low water vapour permeance placed on the outside of a wall need a design check under section 9.25.5 of the 2024 Ontario Building Code: the ratio of outboard to inboard thermal resistance has to meet a table value, or the material has to sit outboard of a drained and vented air space at least 10 mm deep. Ottawa's heating degree-days run from 4,440 to 4,520 depending on the station, which puts the city in the under-4,999 band where the table ratio is 0.20. There is also a separate rule at 9.25.5.1.(4): a material with water vapour permeance of at least 30 ng/(Pa·s·m²) and thermal resistance of at least 0.7 (m²·K)/W does not have to meet that ratio in a location under 6,000 degree-days. Whether a specific insulated vinyl product meets those permeance and resistance thresholds is a question for the manufacturer's data sheet and a designer, not a number to estimate from the product name alone.
A fair quote for insulated vinyl should spell out: the wall area being covered, removal and disposal of the existing cladding, the sheathing membrane (conforming to CAN/CGSB-51.32-M under section 9.27.3.2.), flashing at horizontal junctions and over openings where required under 9.27.3.7. and 9.27.3.8., trim and corner pieces, and what happens to the price if damage is found behind the old siding. Ask for the manufacturer's written installation instructions and warranty in writing before work starts.
The City of Ottawa's permit pages do not list siding or exterior insulation either way, so ask the City's Building Code Services whether your specific scope, including any foam layer, needs a permit.
Want this done at your place?
Tell us about your siding and we'll send it to local Ottawa siding contractors, who reply by email. We send it out to local contractors for you. Free, no pressure.
Siding IQ -- Built from the Ontario Building Code, Ontario regulations and City of Ottawa sources and real construction experience. Answers are for informational purposes only and are not a professional assessment.
Ready to Get Quotes?
Find local siding contractors in Ottawa. Free matching, no obligation.